Cambridge SoundWorks NEWTON HD MC600HD, Руководство пользователя

Страница: 7 / 12

7
Method 2 – Use this method to mount the speaker vertically
when you have less that 21" clearance above the top of the
speaker bracket. Always use method #1 when mounting the
speaker horizontally, and whenever at least 21" clearance is
available.
1. Using the wall mount bracket as a guide, mark at least
four locations for mounting screws in the elongated
keyholes found at the four corners and center sides.
It is best to use the holes at the four outermost corners.
If concealing the wiring in the wall, position the bracket
so the wire exits the wall through the large hole in the
center of the bracket. The wire should extend
approximately 12".
2.
Drill a 1/4" diameter hole and install plastic anchors in
each location. Refer to the instructions in the Appendix
for proper use of the Toggler brand anchors included
with this speaker.
3. Insert #10 screws in each anchor and tighten them until
they extend approximately 1/4". Temporarily place the
bracket in place and tighten the four mounting screws
to the point that the bracket can still be be removed.
You should have to supply slight pressure to slide the
bracket back into place between the wall and screws.
4.
Pass the wire through the center hole of the bracket.
Attach the wire to the speaker terminals. Slide the
speaker on the bracket from the top while guiding the
wire through the middle of the channel formed between
the speaker and bracket.
5.
Pull the speaker logo straight out to remove it. Use a
philips screwdriver to gently tighten the lock screw
concealed in the hole behind the logo to secure the
speaker to the bracket. Do not over-tighten. It only
requires slight pressure! Pay attention to the wire
location so that the screw does not penetrate the
speaker wire. Install the logo with the text upright.
6
. Align the speaker and bracket assembly over the four
screws and press downward about 1/2" so that the
screws lock into the keyhole slots in the bracket. Guide
any slack speaker wire back into the wall as you
position the speaker.
SPEAKER MOUNTING
Note: Screw is already
installed within speaker.
Use philips screwdriver
to tighten. (See #4)