Cambridge Elevating JOURNEY LA, Руководство по установке, Страница: 29 / 40

Testing Safeties
NOTE: Before the cab is installed, make sure the safeties and slack rope switch are activating
properly when the ropes are slack and access is not impeded by the cab walls.
Procedure:
•
Inspect the arm that the slack rope switch is attached to; it should be horizontal. If not,
you will have to loosen the 2 bolts with a 7/16-inch wrench and reposition it
•
Use the remote to move the sling up a foot off the pit floor
•
Place blocking under the sling that is around 12 inches high such that it will hold up the
sling
• Lower the sling ( using the remote ) onto the blocking until the ropes go slack
• Inspect the paddle that the ropes attach to, it should have lowered down onto the slack
rope switch and activated it
•
The knurled rollers should be making contact with the rails and have a little more room
to move. If the brakes do not seem to be adjusted properly, reposition the brakes again
•
The two safeties should be adjusted with the same tension
•
Lift the sling off the blocking using the remote and remove the blocking from the pit
floor