Note: All connections are made using standard loudspeaker cable.
Basic connection
The diagram below shows the basic connection of your unit to a
CD player and a turntable and a pair of loudspeakers.
8
Connections
Loudspeakers
Check the impedance of your speakers. When using a pair of speakers,
you can use types with an impedance of between 4 and 8 Ohms. When
using two pairs of speakers, you must use types with an impedance of 8
Ohms each, see later section.
The red coloured speaker terminals are positive (+) and the black speaker
terminals are negative (-). Make sure correct polarity is maintained at
each speaker connector or the sound can become weak and “phasey”
with little bass.
Using bare wire connections
Prepare the speaker cords for connection by stripping off approximately
10mm (3/8”) or less of the outer insulation. More than 10mm could
cause a short circuit. Twist the wires tightly together so there are no loose
ends. Unscrew the speaker terminal, insert the speaker cable, tighten
the terminal and secure the cable.
L
R
Mains Voltage Selector Switch
115V/230V AC~50/60Hz
Power AC
CD
BD / DVD
MP3 / Aux
MM Phono
Rec Out
Ground
CD
BD / DV
D
MP3 / Au
x
MM Phono
Re
c Out
Right
Left
Right
Left
Loudspeaker Terminals
Impedance 4–8 ohms
Left
Right
A
B
A
B
Left
Right
Manufactured in an
ISO9001 approved facility
AM 300
Ω
FM 75
Ω
Service Port
SR10
Right
speaker
Left
speaker
CD player
Red
Red Black Black Red
Black
Red
Black
Turntable
