cnPilot Enterprise AP
User Guide
CAMBIUM
NETWORKS
45
Figure 13: Configure: Network Configuration page
In the CLI
To switch from configuration context to interface context:
(cnPilot
Enterprise AP
) (configure)# interface eth port-num
To configure port mode (default is trunk mode):
(cnPilot
Enterprise AP
) (configure)# switchport mode
access/trunk
To configure default VLAN of access port (default 1):
(cnPilot
Enterprise AP
) (configure)# switchport access vlan
vlan-id
To configure allowed VLAN range for trunk port (defaults 1 to 4094):
(cnPilot
Enterprise AP
) (configure)# switchport trunk allowed vlan
vlan-range
To specify native VLAN for the trunk port (default 1):
(cnPilot
Enterprise AP
) (configure)# switchport trunk native vlan
vlan-id
To enable native VLAN tagging:
(cnPilot
Enterprise AP
) (configure)# switchport trunk native tagged
To disable native VLAN tagging
:
(cnPilot
Enterprise AP
) (configure)# no switchport trunk native tagged
To display L2 parameters of the ports:
(cnPilot
Enterprise AP
) (configure)# show interface brief
Switched Virtual Interface (SVI)
SVI represents virtual interfaces each mapped to a specific VLAN. Each SVI can have static IP or
assigned from external DHCP server.
Table 13: Configure: SVI parameters
Parameter
Description
Values
Values
IP Mode /
Address
Configures either IP mode to DHCP or static
IP to the SVI.
Note: Each SVI should have IP in unique
subnet.
dhcp
or
ip-addr/mask
dhcp
or
ip-addr/mask