Cambium Networks PTP 450 Series, Руководство по настройке

Страница: 85 / 649

Chapter 1: Configuration Configuring IP and Ethernet interfaces
Page
1-57
Attribute Meaning
VLAN Membership
Table Configuration For each VLAN in which you want the AP to be a member, enter the VLAN
ID and then click the Add Member button. Similarly, for any VLAN in which
you want the AP to no longer be a member, enter the VLAN ID and then
click the Remove Member button.
VLAN configuration for PTP
Applicable products PTP:

BHM

BMS
VLAN page of BHM
The VLAN tab of BHS is explained in Table 17 .
Table 17 BHM VLAN page attributes
Attribute Meaning
VLAN Specify whether VLAN functionality for the BHM and all linked BHS must be
(Enabled) or may not (Disabled) be allowed. The default value is Disabled.
VLAN Port Type By default, this is Q, indicating that it is to operate in the existing manner.
The other option is Q-in-Q, which indicates that it must be adding and
removing the S-Tag, and adding a C-Tag if necessary for untagged packets.
The VLAN Port type corresponds to the Ethernet port of the BHS. Currently,
the internal management interfaces will always operate as Q ports.
Accept QinQ Frames
This option is valid for the Q-in-Q port so that the user may force blocking of
existing 802.1ad Q-in-Q frames. This way, only untagged or single tagged
packets will come in and out of the Ethernet interface. If a Q-in-Q frame is
about ingress or egress the Ethernet interface and this is disabled, it is
dropped and a filter entry will show up on the VLAN Statistics page as
DVLAN Egress or DVLAN Ingress.