Cambex Bus Adapter, Инструкция по установке и эксплуатации

Страница: 25 / 37

Checklist for driver and HBA installation
The following commands may be used to isolate problems
during installation of the fibre channel driver and card. Type
the command shown in
bold and verify the output.
lslpp -l PC1000.driver.obj
must give:
Fileset Path: /usr/lib/objrepos PC1000.driver.obj
Level 01.05.00.00 (or greater)
State Committed
Description Cambex Fibre Channel Adapter Driver
lsdev -Cc adapter
should print a line for each card:
fscsi<x> <x> is a unique number for each SCSI card
Available <SS-SS> <S> is the location in the machine where
the card is installed
Check that the number of SCSI cards and their slots are correct
If
'Available'
then card and driver are installed.
If
'Defined'
or not listed then card was not found.
lscfg -vl fscsi4
should print more information for a card:
DEVICE LOCATION DESCRIPTION
fscsi4 00-03 Cambex Fibre
Channel I/O Controller
Manufacturer................CAMBEX
Machine Type and Model......MC1000F
ROS Level and ID............V2.01.04
Serial Number............... 2354
Displayable Message.........Cambex Fibre ...
Network Address.............500502E020000932
Device Specific.(Z0)........Build:TMNX
23