Caltech Calaer 2 kW, Инструкция по установке и эксплуатации

Страница: 25 / 36

25
OPERATING INSTRUCTIONS
INITIAL START-UP PROCEDURE
After installation and before the heater is run for the first time, the fuel lines
and pump have to be filled with fuel. To achieve this, set the control button
to the maximum temperature. The heater will operate the fuel pump in the
same manner as during a normal start procedure, and fuel will be drawn
into the fuel lines. In case the heater shows an error (because it has failed to
start for two times due to no fuel), briefly disconnect the power leads to the
battery. This will reset the failure mode, after which the heater can be
started again. Repeat this procedure until the complete fuel lines are filled
with fuel. The heater shall now ignite and operate normally.
NORMAL START AND STOP PROCE DURES
The heater is started by turning the control button from ‘off’ to the desired
setting. The heater responds by starting the fuel pump after 3 seconds and
turning on the control button status light. The fuel pump will stop after 7
seconds and the heater will then go to pre-heating mode for 50 seconds
where the glow plug is used to heat the combustion chamber. After pre-
heating the fuel pump is switched on again and combustion will begin. The
glow plug is switched off when stable combustion is detected. For the first
two minutes, the heater will run at maximum output power. After that, it
will start to regulate the power to reach the desired thermostat setting.
To turn off the heater, switch the control button to the ‘off’ position and the
heater will then initialize the shutdown procedure. The shutdown procedure
requires 5 minutes, during which the glow plug and fan will be active to
ensure controlled cool down and removal of fuel residues from the heater.
Once the shutdown procedure has completed the control button status light
turns off.