Via the drip tray
Remove the packaging cap and
replace the end stop on the back
of the drip tray with the straight
push fit connector supplied. Then
connect 15mm pipe to the other
end of the connector and run
it to a safe and visible point of
discharge.
The boiler will have a packaging cap on the
vent / overflow pipe underneath the boiler.
THIS MUST BE REMOVED.
Pull this off in the direction of the arrow.
VENT / OVERFLOW CONFIGURATION OPTIONS
By-passing the drip tray
Remove the packaging cap and
attach the elbow push fit connector
to the vent / overflow pipe on the
bottom of the boiler. Then connect
15mm pipe to the other end of the
connector and run it to a safe and
visible point of discharge.
Page 7
