CalMag CalSoft Series, Руководство пользователя

Страница: 14 / 20

Troubleshooting
- 14 -
SYMPTOM
1. Softener fails
to regenerate
automatically
2. Regenerating
at wrong time
3. Loss of
capacity
PROBABLE CAUSE
A.
Cord plugged into
intermittent or dead power
source.
B. Disconnected meter cable.
C.
Defective power cord.
D. Defective timer, meter or
sensor.
A. Timer improperly set, due to
Power failure.
A. Increased raw water
hardness.
B. Brine concentration and/or
quality.
C. Resin fouling.
D. Poor distribution, Channeling
(uneven bed surface).
E. Internal valve leak.
F. Resin age.
G. Resin loss.
CORRECTION
A.
Connect to constant power source.
B. Reconnect cable.
C.
Replace cord.
D. Replace or Repair.
A. Reset timer.
A. Reset unit to the new hardness
capacity.
B. Keep brine tank full of salt at all
times. Clean it yearly. Salt may be
bridged. If using a salt grid plate
ensure refill water is over it.
C. Call Calmag. Find out how to confirm
it, clean the resin and prevent future
fouling.
D. Call Calmag. Check distributors and
backwash flow.
E. Call Calmag. Replace spacers, seals
and/or piston.
F. Call Calmag. Check for resin
oxidation caused by chlorine. Mushy
resin.
G. Call Calmag. Check for correct bed
depth. Broken distributors. Air or gas
in bed: Well gas eliminator. Loose
brine line.
H. Close bypass valve.
I. Check for too slow or high service
flow. Check for media fouling.
4. Poor water
quality
A. Check items listed in *3
B. Bypass valve open.
C. Channeling.
A. Adjust salt setting.
B. See symptom No.7
If any of the above occur please contact Calmag prior to any work being undertaken otherwise any guarantees may become invalid.
CalSoft Mini, Midi & Maxi
7. Further Information