6
ASSEMBLY
1. Make sure the valve knob is turned all the way clockwise to the CLOSE position as shown in
Figure 1.
Figure 1
2. Place the aluminum washer (AM0972) on the umbrella hole on the table top as shown in below
Figure 2, and then place the firepit base on the center of the umbrella base hole, and have the gas
tube of the regulator go through the aluminum washer and umbrella hole.
Figure 2 Figure 3
3. Place another aluminum washer (AM0972) at the gas tube of the regulator as shown in Figure 3.
4. Screw the ‘Butterfly’ nut (AM0982) into the gas tube of the regulator, and tighten it as shown in
Figure 4.
Figure 4
Figure 5
5. Screw the Propane Cylinder clockwise into the gas tube as shown in Figure 5. Hand tighten only.
Do not cross thread. Use only a 16.4 oz (465g) cylinder with a NO.800 connection.
Do not use a 14.1 oz (400g) cylinder.
To check for leaks
: Use a solution of water and dish
soap and brush around the connection between the gas tank and valve component. If you see any
