Caliber MCD-163, Инструкция по эксплуатации

Страница: 8 / 19

Switching on/off the unit
Switch on the unit by pressing any button
(except
button and button) or inserting
a disc to disc slot.
When system is on, press the
button to
turn off the unit.
Sound adjustment
- Rotate the volume knob on the head unit to
adjust volume level.
- Press the
button to enter into the
audio selecting mode. Press this button
continually will change in the following
order:
SEL
When TP information gets lost at the
current station for retune time, the beep
sound is out-putted.
When newly tuned station has not RDS
signal, “PI SEEK” is suppressed somewhat.
Rotate the volume knob button to adjust the
desired sound quality.
- for 2
seconds to enter into the menu mode
Press it continually, it is activated as
cyclical mode of following functions for
user's selection
Press and hold the button
Rotate the volume knob to select the
desired item.
SEL
.
:
TA SEEK/ALARM PI SOUND/MUTE RETUNE L/S
MASK DPI/ALL BEEP 2’ND/ALL/OFF
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
TA SEEK/ALARM
- TA SEEK mode:
- TA ALARM mode:
When newly tuned station does not
receive TP information for a few seconds,
the radio retunes to next station which has
not the same station (PI) as the last station,
but has the TP information.
When TP information gets lost at the
current station for retune time which is set
by RETUNE SHORT (30 sec.) or RETUNE
LONG (90 sec.), the radio start to retune to
next same PI station. When same PI station
does not catch in 1 cyclic search, the radio
retunes to next station with TP information.
When this mode is selected, any
automatic retune mode is not activated.
Only double beep sound (ALARM) is
output.
When newly tuned station does not have
TP information for several seconds, beeps
come out.
PI SOUND/MUTE
While AF switching is implemented in
C201 station, AF can switch to 100 MHz,
which is non genuine AF (where, different PI
with same AF) in short “DIP”.
If a car cruises that critical area back and
forth, an oscillation phenomenon can be
occurred, because the different PI code can
be received from 100 MHz with “XXX” PI.
The car radio has special procedure to
reduce even this kind of unavoidable
situation however there is a limit to be
escaped from this serious case perfectly.
In that serious case, 2 modes are
selectable as follows:
The AF frequency (which has different PI
or NO RDS signal with high field strength) is
masked during checking PI when the unit
- PI SOUND mode:
- PI MUTE mode:
- RETUNE L mode:
- RETUNE S mode:
When above different PI sound (DIP) is
heard once in a while, the Dip's sound will
be heard for a short time.
Under above same situation, a mute
sound will be heard for a short time.
The initial time of automatic TA search or
PI search modes is selected.
When PI information is not caught for
retune time, the radio starts to retune to
next same PI station.
When same PI station does not catch 1
cyclic search, the radio goes to last station
and waits for several minutes until PI code
is received.
Selected as 90 seconds.
Selected as 30 seconds.
RETUNE L/S
MASK DPI /ALL
General Operations