CalderaSpas Utopia, Инструкции перед доставкой

Страница: 12 / 16

Pre-Delivery Instructions
Page 12
P
OWER
C
ONNECTION
To connect power to the spa, refer to “230 VOLT WIRING SCHEMATIC DIAGRAM” and “POWER
CONNECTION ACCESS” illustrations on page 11 , then proceed with the following steps:
When supplying power, remove the screws securing the equipment door (for Utopia and Aquatic Melodies ® spas, always
remove the SpaGlo ® exterior light fixtures and lift the fiber optic cable out of the fixture base before removing the doors).
Lower the panel one inch and remove the panel to allow access to the input power wiring.
NOTE:
The 230V wiring diagram is located on the inside of the Control Box Cover.
IMPORTANT: The following must be followed to properly install the equipment compartment door.
• Place top of door or panel directly below bartop against the frame of the spa. For Utopia and Aquatic Melodies spas, first
lift the fiber optic cable out of the way.
• Push bottom of door or panel against the spa frame.
• Slide door or panel upward (pushing in on center of door to ensure door clips catch) until screw holes line up, making
sure that the exterior fiber optic light cable will fit into the fixture.
• Slightly pull on door or panel, if door remains against the spa then replace the screws.
• If the door does not lock into position, repeat the previous steps.
S
ERVICES
A
VAILABLE
F
ROM
Y
OUR
C
ALDERA
®
S
PA
D
EALER
Service Cost
Pre-Delivery site inspection ______________
Deliver spa to installation site ______________
Unwrap spa and haul away packaging material ______________
Set up spa ______________
Fill the spa with water ______________
Explain and test the spa’s operation
Lighting • Sound system (Aquatic Melodies ® spas only) • Set temperature control
• Control panel functions • Auxiliary panel functions (Utopia and Aquatic Melodies ® spas only)
Explain the safety features
• GFCI • Heater high limit
General spa operation & maintenance orientation ______________
Water quality and maintenance orientation ______________
Adjust the water’s pH, Total Alkalinity and Calcium Hardness ______________
Sanitize the water ______________
Inspect the spa cover, place on spa, and install cover locks ______________
Review winterizing instructions ______________
Review Owner’s Manual & Warranty Card ______________
Follow-up call ______________
In-store spa water analysis ______________
TOTAL COST
______________