Calculated Industries Ultra Scale Master 6250, Руководство пользователя

Страница: 28 / 35

There are two methods for programming Custom Scales into
your Ultra Scale Master. “Measured Custom Scales” allow
you to measure a specifi ed Length and assign the known
value. “Entered Custom Scales” allow you to enter and set a
known scale that is not included within the available built-in
scales of the Ultra Scale Master. One Custom Scale can be stored in Imperial and Metric
Modes for a total of two Custom Scales. Once a Custom
Scale has been set in either mode, it is retained until a new
scale is stored in its place or until an All Clear or Reset is
performed. Switching between Imperial and Metric Modes
does not clear stored Custom Scales.
SETTING A MEASURED CUSTOM SCALE
CUSTOM SCALES
1. Press [MODE] until “CUST” is displayed.
2. Press [SET] then [SCALE] to begin setting the Custom
Scale. The display prompts you to enter Point-1.
3. Place the crosshairs over the start point of the line and
press [MEASURE]. You are prompted to enter Point-2.
4. Place the crosshairs over the end point of the line and press
[MEASURE] . The display shows “0,000-00” for Imperial
Mode and “00,000.0” is displayed for Metric Mode.
The following example is shown in Imperial Mode. The displays will be slightly different if in Metric Mode.
(Cont’d)
U
SER’S
G
UIDE
— 25