Calculated Industries Ultra Scale Master 6250, Руководство пользователя

Страница: 31 / 35

28 — U
LTRA
S
CALE
M
ASTER
®
LINEAR UNITS
Feet-Inch (FEET INCH)*
Feet (FEET)
Yards (YD)
Meters (M)**
Centimeters (CM)
Millimeters (MM)
Inch (INCH)
AREA UNITS
Square Feet (SQ FEET)*
Square Yards (SQ YD)
Acres (AC)
Square Meters (SQ M)**
Square Centimeters (SQ CM)
Square Millimeters (SQ MM)
Hectares (HA)
Square Inches (SQ INCH)
UNITS OF MEASUREMENT
The following units of measurement are available for selection by pressing the [UNITS] key located under the slide cover door.
You may change the units of measurement of a displayed value at anytime during measuring, or after a measurement has been
completed. All of the linear and area units shown below are available in both Imperial and Metric modes and are displayed
in the order shown beginning with the default. The Imperial/Metric switch (located on the back of the puck) determines the
default starting unit:
Note: You may change units on any displayed value, even while measuring. Continuous presses of [UNITS] will scroll through the available
units of measurement listed above, converting the displayed value. If the value is too large to be displayed in the units selected, the display
will remain unchanged (maintaining the same value and units) until the value is converted to a unit that can be displayed.
*Imperial Default
**Metric Default
Note: If a measurement or calculation with small units of measurement
exceeds the seven-digit range of the display, it will be automatically
displayed in the next larger units (e.g. 20,000,000 millimeters is
displayed as 20,000.00 m).