Calcana SR Series, Спецификации, руководство по установке, эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 8 / 96

SR -SERIES
4
3.0
CODE COMPLIANCE
Installation shall be in accordance with local building codes, or in the absence of local codes, in accordance
with:
FUEL SUPPLY:
CANADA: Natural Gas and Propane Installation Code, CSA B149.1 or latest edition.
USA: National Fuel Gas Code, ANSI Z223.1/NFPA 54, or latest edition.
ELECTRICAL GROUNDING:
CANADA: Canadian Electrical Code, CSA C22.1 or latest edition.
USA: National Electrical Code, ANSI/NFPA 70 or latest edition
In Canada: Electrical equipment and wiring shall comply with the applicable provisions of the current
Canadian Electrical Code, CAN/CSA C22.1, Part I and Part II, and CAN/CSA C22.2 No.3, Electrical
features of Fuel Burning Equipment
.
PUBLIC GARAGE INSTALLATION:
Adequate clearances must be maintained according to the following standards:
CANADA: Natural Gas and Propane Installation Code, CSA B149.1 or latest edition.
USA: Parking Structures, ANSI/NFPA 88A or the standard for Repair Garages, ANSI/NFPA 88B or latest
edition.
AIRCRAFT HANGERS:
Adequate clearances must be maintained according to the following standards:
CANADA: Enforcing Authority .
USA: Aircraft Hangers, ANSI/NFPA 409
Check line and manifold pressure with a manometer to confirm unit is set according to the specification on
the rating plate. Perform check with all gas-fired appliances operating. (See pages 67, 73 & 74 for further
details).
Provide adequate accessibility clearances for servicing.
Leave copy of this manual with owner (or a copy) for future reference.
DO NOT INSTALL THIS UNIT IN RESIDENTIAL SPACES
HEATER OPERATION NOTE: Heater will have a higher heat output at the burner end as compared to the
exhaust end.
SPACE HEATING: As a general rule, it is suggested to locate the burner end toward the highest heat-loss area
(doors) of the space being heated. If you have any concerns or questions concerning orientation or layout of
the heater in your application, contact factory for assistance.
SPOT HEATING: On heaters with a straight line configuration as well as units that have the maximum length
of radiant tube selected for the input capacity of a given burner, there will be a noticeable and more
pronounced perception of greater heat output from the burner end of the heater as compared to the exhaust
end. As a general rule, it is suggested for spot heating applications, to use a u-tube configuration to provide
a more even source of heat. If you have any concerns or questions concerning orientation or layout of the
heater in your application. Contact factory for assistance.
NOTE: Condensation from the exhaust may occur from this heater when it starts the heating cycle. The
condensation will stop once the heater warms up. Make sure venting is sealed according to section titled
"VENTING" on page 49.