15
16
Product User Manual
Installation for the battery pack can be followed as five steps.
The first step: Arrange the single batteries equipped with protection components and fastening
clamps in alignment (take 3 batteries for example); with fastening clamps laid at both ends of the
battery pack. As shown in figure 7.
Figure 7
Fastening clamp
Before installing, do check and make sure the protectors no cracks, no scratches, and no deformation;
Make sure not to scratch the battery surface and make sure battery placement accordance with electrical drawings during installation;
Make sure that the mounting holes are aligned when integrating the packs; otherwise it will affect the screw installation, causing
protectors’ scratch;
Install the pole protectors promptly after connecting the bus bars, and prevent cascading battery packs from short circuit caused by
foreign objects;
The integrated packs should be placed on a workbench with flat and dry surface.
The completion of battery packs’ protector installation is shown above.
Step 2: Select screws of appropriate length to run through mounting holes of fasten clamps and
single battery protectors, as shown in figure 8.
Step 4: Install the bus bar. Assemble the bus bars according to grouping way, as figure 10.
Step 5: Install the pole protectors as shown in figure 11.
Step 3: Install nuts (including flat and spring washers) as figure 9.
3. Attentions
Figure 9
Pole protectors
Figure 11
Figure 8
Screw
Screw
Flat washer
Spring washer
Screw
(a)
Screw
(b)
Figure 10
Bus bar
