Condition
LED 2
GPS Off
Off
GPS On
Slow Blinking
GPS Time Sync Fast Blinking
GPS Fix
Solid
4 Configuration and Activation
This section details how to quickly get an LMU-4530™ provisioned and configured to point at a specific server.
It is assumed that a PEG script has already been created and is being managed through LMU Manager or
PULS™, the CalAmp Maintenance System.
We are making three assumptions to simplify the setup process:
You have created, installed and configured an LM Direct™ Server to receive messages from the
LMU-4530™. (See
LM Direct™ Reference Guide
for details)
You are using the standard wiring harness from CalAmp and the serial port expansion harness.
You have created a HyperTerminal or Putty session.
You have contacted the CalAmp sales team regarding the network availability of the LMU-
4530™.
This device may not be supported for all the carriers or networks listed in this section
(CDMA-Verizon, CDMA-Sprint, HSPA, GSM), for product availability consult the CalAmp sales
team.
4.1 Quick Start - General Config
All LMU-4530s™ must go through a common step during the configuration and provisioning process.
Specifically, this is pointing the LMU to your LM Direct™ server, either via IP or a URL.
This configuration process is accomplished via a series of AT Commands:
1. Power up the LMU-4530™ and connect a serial cable from the LMU to your laptop
2. Open a terminal session to the LMU-4530™
3. Enter the address of the LM Direct™ server:
