PYROSTAR
–
SMOKE FAN F400-120
MS-MTG-001
Ind E
01/10/2019
Page 3/8
I.
AT DELIVERY
I.1.
Checkings at delivery
When the equipment is received, the state of the packaging and the equipment must be checked. In the event of damage, make an accurate note of
any problems on the carrier's delivery note.
I.2.
Unpacking
When the equipment is unpacked, check the following:
- The total number of packages are present.
- All accessories are present (dampers, roof, electric switchgear, etc.). After unpacking the equipment, the waste must be disposed of in compliance
with the current standards. No packaging should be discarded into the environment
I.3.
Storage
The equipment must be stored in shade, in a dry place, at a temperature between -20°C and 40°C.
II.
INSTALLATION
II.1.
Handling
The units must only be moved in their installation position.
If the device is handled using a fork-lift truck, ensure this supports the load-bearing structure and does not touch the panels enclosing the unit.
If the device is moved using a crane, use four cables of identical lengths. These must be at least as long as the greatest distance between two
fastening points.
If dimensions L + W + H > 5m Þ then the case must be lifted using a lifting beam.
In compliance with the current norms, the machine should be installed only by a technical person qualified
for this type of work. During installation, ensure that:
- The machine is moved as given in chapter II.1.
- The required personal protection devices are worn so as to avoid injuries caused by electrical
and mechanical hazards (injuries by touching panels, sharp edges, etc.)
- Electrical connections are made after the power supply has been shut off, in compliance with the
recommendations given in chapter III.
- Grounding is carried out in compliance with current standards.
- The machine is powered on when installation has finished (ducting installed and inspection doors
closed).
