Cal-Royal CR6000 SERIES, Руководство по установке

Страница: 6 / 26

Installation Instructions for Electronic Stand-Alone Cylindrical Locks
- 6 -
B.
Position Template and Mark Drill Points
Be
sure to verify backset before marking and drilling
door.
1. Fold and Place template on high edge of door at
the horizontal centerline.
2. Mark centers of holes at proper backset. For
beveled and square edge doors, mark both sides
of the door.
C. Drill Holes and Mortise for Latch face
1. Drill 2-1/8"(54mm) diameter hole through the door.
Cut notches as shown on template.
2. Drill 1"(25mm) diameter hole through the door
according to template.
3. Drill 1"(25mm) diameter hole in edge of door.
Mortise for latch front 5/32"(4mm) deep 1-1/8"
(29mm) wide × 2-1/4"(57mm) high.
4. Drill three (3) 3/8"(9.5mm) diameter holes through
door.
5. Drill the holes for the screws used to install the
latch. 7/64"(2.5mm)
Note: To avoid splintering wood doors, drill holes from
both sides of the door.
D. Prepare and Install Strike (Wood Frames Only)
1. Mark vertical line and centerline on frame exactly
opposite center of latch hole.
2. Drill two (2) 1"(25mm) holes 5/16"(8mm) above
and below centerline.
3. Mortise a cutout for strike. Use strike as a pattern
for mortise. (Strike should fit flush with frame.)
4. Drill the holes for the screws used to install the
strike. 7/64"(2.5mm)