P4, P5, and P6 Barbecue Grills
LTR50001137, Rev. Q
Installation and Connection
www.calflamebbq.com
10
Installation and Connection
Connecting the Grill and Side Burner
These instructions show you how to connect a grill only or a grill and side burner combination.
If you plan to convert to your grill from LP to NG, you need to do this before it is connected to a gas source.
Grill conversion instructions can be found on page 31 and ordering information can be found in this manual on
page 37. There are a few differences between connecting to LP and NG.
You will need a second
person to help you to
avoid damaging the grill,
the transformer, or your
barbecue island .
Before installing a grill or side
burner in any island or cut out,
make sure that the opening is
not bigger than the outside
frame of the grill unit. The grill
should rest on the lip of the
frame. For drop-in accessories,
adequate cross ventilation must
be designed into enclosure
to ensure the drop-in grill or
side burner does not become
overheated.
Pay careful attention to the location of gas lines.
Gas lines should be routed away from sources of
heat and should make as few bends as possible.
Check to see if gas line connections will be accessible
when grill is installed.
•
If gas line connections are not easily accessible
when the grill is installed, support the grill
above counter level and attach the gas lines to
the grill. When the gas connections are made,
slide the grill into the cut out.
•
If gas line connections are accessible when the
grill is installed, slide the grill into the cut out
and then attach the gas lines.
1 .
Place the Grill and Side Burner in the Cut-outs
Be very careful not to kink gas lines when lowering the
grill or side burner into the cut out.
Keep your fingers away from where the grill will be
supported on counter. Your fingers could become
trapped and serious injury could occur.
Check to make sure the grill is level and is supported
around the entire outside edge. If the grill is not level
or is unstable, use non-combustible shims under the
outside lip to stabilize it.
Perform the leak test procedure as described earlier
in this manual.