After a device group was selected, a further detailed selection based
on the size of the chip has to be chose, to help the user more quickly
locate his target.
If you want to do the download, insert the ICs into the slave textools
before you depress the [key3] to have them be checked or erased to their
blank status.
+Name
[key2 + key3],
-Name
[key1 + key2]:
[PROM8908D/E, PROM980x]
Select the next device name for operation. The arrangement of the
name's sequence is from smaller to larger size with the EPROM group
comes first, followed by some special devices and then the FLASH
group.
The -Name circulate the name list in opposite direction as the
+Name does.
[PROM8908F]
Select the next device name in this device group for operation. Only
the devices of this size category will be shown and can be chose. You
can't find device name not belong this size or type.
4. Steps for upload, download and calibration
4.1
When the LCD shows " Download Rdy " message, following the
steps below to complete the
Download:
(This procedure can be abort at this time by depressing the key1+key3)
1.
If you see a " Clear buffer?" message before " Download Rdy ", that
means there is already a byte received and, what you want to do on it?
Yes[key1] will drop it and waiting for the next data come in, which is
the most usual choice. No[key2] will write this data as the first byte into
the IC.
2.
Run the PROMUTIL.EXE utility on the PC and follows its
instruction. (use /I switch to set the LPT port number as required.)
7
