CAIRE Hi Flow Stroller, Техническое и сервисное руководство

Страница: 27 / 38

Hi Flow Stroller Technical Service Manual • PN 14314465 Rev F
26
H
i F
lo
w S
tr
oller
Repair Procedures
X
RP10 – Resolder Feed-thru Wire (Figure 11)
a Remove manifold assembly (See RP 9).
b. Strip approximately 1/8” (0,3 cm) of insulation from feed-thru
wire if necessary.
c. Apply small amount of Stay-Clean flux to tinned area of probe
using a cotton swab.
d. Resolder feed-thru wire to tinned area of probe. Add small
amount of lead-free solid wire solder if necessary.
e. Clean flux residue with distilled water and cotton swab. Dry
thoroughly.
f. Replace manifold following listed procedure (RP9).
FIGURE 11: Feed-thru Wire
RP8 – G4 Meter RR
a. Remove shoulder strap, unzip top case zipper, and fold back top
flap.
b. Remove 2 meter mounting screws.
c. Remove meter assembly.
d. Unplug the wiring connection.
e. Disconnect ground wire spade terminals.
f. To replace G4 meter, reverse above procedures.
RP9 – Manifold Assembly RR (Figure 11)
a. Remove soft case and Gen 4 meter. (RP 4,8).
b. Remove (3) bracket screws (Item 29) and lift bracket (Item 28)
from manifold.
c. Loosen and disconnect breathing coil nut (Item 38) from with-
drawl fitting and FCV (Item 24). Be careful not to bend or kink
Teflon® tubing.
d. Loosen and disconnect primary relief valve tube (Item 46) and
vent outlet tube from manifold fitting.
e. For top fill units, loosen and remove QDV tube from manifold
fitting.
f. Use a hex wrench to loosen and remove the (4) manifold retaining
screws (Item 31).
g. Remove manifold assembly (Item 41) by lifting straight up.
i. To replace manifold, reverse above procedure.
CAUTION:
Be careful not to pinch wires!
WARNING: The unit must be empty, warm and vented before
starting procedure.
NOTE: Ensure proper seating of O-ring in dewar. Apply small
amount of fluorolubricant to O-ring before assembly. Torque
mani-fold mounting screws (Item 31) to 2 1 –2 3 in-lbs (2 37 –2 6 0 N-
cm) us-ing cross-tightening method.
NOTE: If substantial force is required, closely examine wire and
probe for damage.