8
1. Combine the Mount with the Main Body.
2. Fix firmly the Main Body and the Mount using Setscrews.
3. Adjust the installation angle to align the Main Body vertically.
4. When the angle is properly adjusted, tighten the Setscrew using a coin.
5. Insert the SD Memory Card into the Main Body.
6. Connect the Power Cable Jack to the Main Body.
7. Remove the backing from the adhesive mounting tape
8. Locate the system in the middle of windshield
9. Use the fix clip to fix the cables.
10. When the angle and cables are properly adjusted, connect the power cable to
cigar jack
(8) Instructions for use
-
Operating the product
1. First, check whether SD Memory Card is inserted in the Main Body.
2. If the vehicle engine gets started, the power will be automatically supplied.
3. Once power is supplied, the initialization of the Product will proceed, and the red
LED and blue LED will flash repeatedly.
※
If SD Memory Card is not inserted or an error occurs, red/blue LED blink
repeatedly and beep will sound continuously until SD Memory Card is
inserted or the Product is powered off.
4. When the initialization is completed, red LED will flash on after beep sounds five
times.
※
In case of the Product without GPS built in (HD-2100), both red/blue LEDs
will blink at the same time after the completion of the initialization.
5. Video recording proceeds normally when operating the vehicle.
1) Image recording in an
ordinary mode setting
After power is supplied, video recording is being done in 5 minutes process time
unit. In case that an event occurs, the exact location where the event occurs at the
particular time will be stored.
