9
English
Alarms
The appliance has the ”
Froth and heat milk
" (
WHITE LED
) and "
Froth milk without
heating
" (
BLUE LED
) buttons lit up at the same time, as shown in fi gure 1, when:
•
Any button is pressed and the milk container is not in the base.
•
Any button is pressed and there is no milk in the container.
•
Any button is pressed and the mixer/frother insert is not inside the container.
•
The milk container is removed from the base when the cycle has not fi nished.
IMPORTANT NOTE: To reset the alarm and return to operation status, press any
button TWICE.
Frothing and heating milk
•
Place the appliance on a fl at surface.
•
Remove the container from the base.
•
Remove the lid and make sure the mixer/milk frother insert is inside the container.
•
Fill the container with the recommended amount of milk, put back the lid and the
container inside the base.
Note
: For better froth, use milk straight from the refrigerator (approx. 3°-5°C).
To prevent the milk from spilling after frothing, the maximum recommended amount of milk
(150ml) must not exceed the line mark
MAX FROTH
; this is because when frothed, milk
increases its initial volume.
•
Insert the plug in a power socket. The appliance will beep.
•
Press the button
A
; the other buttons go off . The milk frother will start rotating and
frothing the milk. When the required temperature is reached, the milk frother insert
stops; the appliance beeps and all the buttons light up.
Note
: The cycle can be stopped in advance by pressing the button once. Do not remove the
milk container during operation.
•
When the appliance stops, remove the container from the base and pour the hot frothed
milk (Fig.2).
•
Always switch the appliance off by disconnecting it from the mains after use.
Note
:
It is advisable to clean the appliance of any milk residues after every use, to
avoid risks to health and prevent malfunctioning.
