49-85255 Rev. 1
25
Oven Door
NOTE:
The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
Before replacing the bulb, disconnect electrical power to
the oven at the main fuse or circuit breaker panel. Let
the bulb cool completely before removing it. For your
safety do not touch a hot bulb with a damp cloth. If you
do the bulb may break.
To remove:
7XUQWKHJODVVFRYHUFRXQWHUFORFNZLVHWXUQXQWLOWKH
tabs of the glass cover clear the grooves of the socket
and pull the cover off. Remove the bulb.
To replace:
Put in a new 40-watt appliance bulb. Place the tabs of
the glass cover into the grooves of the socket. Turn the
JODVVFRYHUFORFNZLVHWXUQ
NOTE:
Ŷ
A 40-watt appliance bulb
is smaller than a standard
40-watt household bulb.
Ŷ
Reconnect electrical power
to the oven once the new
bulb is installed.
Ŷ
For improved lighting inside
the oven, clean the glass
cover frequently using a
wet cloth. This should be
done when the oven is
completely cool.
Bulb
Socket
Tab
3
1
»
2
”
Max
length
Glass cover
The door is very heavy. Be careful when removing and lifting the door. Do not lift door by the handle.
To Remove the Door:
1. Fully open the door.
2. Pull the hinge locks up and away from the range
frame to the unlocked position.
3. Firmly grasp both sides of the door near the top.
4. Close door until the top of the door is approximately
6” from the range frame.
5. Lift door up and away from the range until both hinge
arms are clear of the slots in the range frame.
To Replace the Door:
1. Firmly grasp both sides of the door near the top.
2. With the door at the same angle as the removal
position, rest the notch on the underside of the left
hinge arm on the bottom edge of the left hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for the right side.
3. Fully open the door. If the door will not fully open, the
notches in the bottoms of the hinge arms have not
seated correctly in the bottom edge of the slot. Lift the
door off the range and repeat previous step.
4. Push the hinge locks toward the range cavity and
down to the locked position.
5. Close the oven door.
Removal position
Pull hinge locks up to unlock
Push hinge locks down to lock
Rest notch on bottom edge
of hinge slot
Notch
Bottom
edge of
slot
Hinge arm
WARNING
SHOCK OR BURN HAZARD:
Before replacing oven light bulb, disconnect the electrical power to the
range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
CAUTION
BURN HAZARD:
The glass cover and bulb should be removed when cool. Touching hot glass with
bare hands or a damp cloth can cause burns.
Oven Light
CARE
AND CLEANING:
2YHQ
/LJKW
2YHQ
'RRU
Содержание CGB500P
Страница 29: ...49 85255 Rev 1 29 Notes...
Страница 61: ...49 85255 Rev 1 29 Notas...
