Document type:
Title:
Revision date:
Revision:
User's Manual (MUT)
Mod. NIM8304 12 slot 7U(5+2) Switching NIM Crate
14/04/2014
3
NPO:
Filename:
Number of pages:
Page:
00121/09:N8304.MUTx/03
NIM8304_REV3.DOC
44
29
5. NIM8304 Operating
5.1 Safety information and installation requirements
5.1.1 General safety information
This section contains the fundamental safety rules for the installation and operation of the
boards. Read thoroughly this section before starting any procedure of installation or
operation of the product.
5.1.1.1
Safety Terms and Symbols on the Product
These terms may appear on the product:
•
DANGER
indicates an injury hazard immediately accessible as you read the marking.
•
WARNING
indicates an injury hazard not immediately accessible as you read the
marking.
•
CAUTION
indicates a hazard to property including the product.
5.1.2 Injury Precautions
Review the following precautions to avoid injury and prevent damage to this product or
any products connected to it. To avoid potential hazards, use the product only as
specified. Only qualified personnel should perform service procedures.
5.1.2.1
Caution
The following safety precaution must be observed during all phases of operation, service
and repair of this equipment. Failure to comply with the safety precautions or warnings in
this document violates safety standards of design, manufacture and intended use of this
equipment and may impair the built-in protections within.
CAEN shall not be liable for user’s failure to comply with these requirements.
To avoid electric shock or fire hazard, do not apply a voltage to a load that is outside the
range specified for that load.
To avoid electric shock or fire hazard, do not operate this product with covers or panels
removed.
Do Not Operate Without Covers.
To avoid electric shock or fire hazard, do not operate this product with covers or panels
removed.
Do Not Operate in Wet/Damp Conditions.
To avoid electric shock, do not operate this product in wet or damp conditions.
Do Not Operate in an Explosive Atmosphere.
To avoid injury or fire hazard, do not operate this product in an explosive atmosphere.
Do Not Operate With Suspected Failures.
If you suspect there is damage to this product, have it inspected by qualified service
personnel.
WARNING: DO NOT TOP LOAD
5.1.3 Input ratings
Do not use AC supply, which exceeds the input voltage and frequency rating of this
instrument. For input voltage and frequency rating of the module see § 2.1. For safety
reasons, the mains supply voltage fluctuations should not exceed above voltage range.
