Document type:
Title:
Revision date:
Revision:
User's Manual (MUT)
A3000NF 3Phase Notch Filter for A3486
18/06/2008
4
NPO:
Filename:
Number of pages:
Page:
00120/04:3000N.MUTx/04 A3000NF_REV4.DOC
13
11
2.1.5 Live
circuits
Operating personnel must not remove the instrument cover. No internal adjustment or
component replacement is allowed by non-CAEN personnel. Never replace components
with power cable connected. To avoid injuries, always disconnect power, discharge
circuits and remove external voltage source before touching components (wait 15 min at
least).
2.1.6
Parts substitutions and modifications
Parts substitutions and modifications are allowed by authorized CAEN service personnel
only.
2.2 Installation
This Chapter contains instructions for initial inspection, preparation for use and
repackaging for shipment.
2.2.1
Preparation for use
In order to be operational the unit must be connected to an appropriate AC source. The
AC source voltage should be within the unit specification. The A3000NF shall be
connected to the AC source in the following way.
Fig. 2.1 – AC source connection
2.2.2 Initial
inspection
Prior to shipment this unit was inspected and found free of mechanical or electrical
defects.
Upon unpacking of the unit, inspect for any damage, which may have occurred in transit.
The inspection should confirm that there is no exterior damage to the unit such as broken
knobs or connectors and that the front panel and meters face are not scratched or
cracked. Keep all packing material until the inspection has been completed. If damage is
detected, file a claim with carrier immediately and notify CAEN service.
2.2.3 Rack
mounting
The Mod. A3000NF is an equipment for BUILDING-IN: it must be installed in a 19”
equipment rack and operated with its upper grid unloaded.
Use the front panel rack-mount brackets to install the unit in the rack.
This product must be installed by qualified personnel; EMC filter
Mod. CAEN A3000NF does not support operation in hostile areas
(magnetic field).
