Caen RFID Hadron R4320C, Техническое руководство

Страница: 30 / 35

REGULATORY COMPLIANCE – Hadron R4320C - Technical Information Manual 30
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
a. Reorient or relocate the receiving antenna.
b. Increase the separation between the equipment and receiver.
c. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
d. Consult the dealer or an experienced radio/TV technician for help.
This transmitter module has been tested and found to comply with Part 15 of the FCC Rules.
NOTE:
a. Any changes or modifications not approved by CAEN RFID could void the user authority to operate the
equipment.
b. Hadron R4320C module is approved for operation with the following antennas:
−
CAEN RFID antenna Mod. WANTENNAX020 Circular polarized antenna FCC with 5.5dBi gain
−
CAEN RFID antenna Mod. WANT021XMMCX QUAD Circular Polarized Quadrifilar Antenna FCC with 0.7dBi
gain
c. Use of other than the approved antennas with this unit may result in harmful interference with other users and
cause the unit to fail to meet regulatory requirements.
d. The device requires professional installation since one of the approved antennas (CAEN RFID mod.
WANTENNAX020) has a standard type N connector.
e. The device shall be used such that a minimum separation distance of 25cm is maintained between each antenna
and user/nearby people body.
f. This transmitter module is authorized to be used in other devices only by OEM integrators under the following
conditions:
1. The RFID Module antenna shall have a separation distance of at least 25 cm from all persons
2. The transmitter module must not be co-located with any other antenna or transmitter
g. The host integrator installing this module into their product must ensure that the final composite product
complies with the FCC requirements by a technical assessment or evaluation to the FCC rules, including the
transmitter operation and should refer to guidance in KDB 996369.
h. The module is authorized for FCC part 15.247 only, the host product manufacturer is responsible for compliance
to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
i. The module has been tested and found to comply with the limits for a Class B digital device, however the final
host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
j. If the FCC ID is not visible when the module is installed inside another device, the OEM integrator shall apply a
label in a visible area on his product with the following statement:
Contains Transmitter Module FCC ID: UVECAENRFID027
or
Contains FCC ID: UVECAENRFID027
See § Hadron R4320C FCC Grant part B page 33 and Hadron R4320C FCC Grant part C page 35 for the Hadron
R4320C FCC Compliance Certificate.