Caen RFID easy2read Lepton3x1, Техническое руководство

Страница: 14 / 31

HARDWARE INTERFACE - Lepton
3
x1 - Lepton
3
x4 - Technical Information Manual 14
Wakeup Pin
The WKUP pin is used to wake the device when it is in the Standby or Sleep operating modes. This pin is
edge sensitive and will wake the device on a rising edge. The WKUP pin must be logic low in order for the
device to re-enter Idle mode after a Sleep wakeup, so it should only be pulsed high to wake up the part.
The WKUP pin operates at a 3.3 V logic level. It has a 35 k Ω t ypical pull-down resistor inside the R3101C
Lepton
3
x1/R3104C Lepton
3
x4. Voltages outside of the maximum IO operating voltage range of -0.3 to 4.0
V should not be applied to the WKUP pin. This can cause permanent damage to the device.
If the WKUP pin is not used, it should be left floating or tied to logic low (ground).
External Connections and Mechanical Drawings
The location of the connectors is shown in Fig. 3.3: R3101C Lepton3x1 mechanical drawings and connectors
locations (units: mm) and Fig. 3.4: R3104C Lepton3x4 mechanical drawings and connectors locations (units: mm).
Their part numbers are listed here below:
Antenna Ports : RF Coax Connector Huber+Suhner type 82_MMCX-S50-0-2/111_K (to be used with
Huber+Suhner type 11_MMCX-50-1-1/111_O)
MOLEX Connector : PCB Header Molex type 53261-1571 (to be used with Molex Type 51021-1500 + 15pcs
crimp terminal type 50058-8100)
Fig. 3.3: R3101C Lepton
3
x1 mechanical drawings and connectors locations (units: mm)