Cadman TRAVELLER 2250, Руководство оператора и каталог запасных частей, Страница: 8 / 56

6
5 Check for oil level in the indexer gearbox.
6 Check the tire pressure and m
aintain from 36-40 PSI .
EVERY 250 HOURS OF USE
Disassemble, clean, inspect and re-pack the gun cart
wheel bearings. Replace any defective components as
required.
BEFORE STORING
1 Drain the hose. This is easily done by pulling out all
but one (1) coil of hose along a level path. Remove the drain plug from the gun cart. Use the
Honda engine or a tractor PTO shaft to wind in the hose.
2 Disassemble and clean the variable speed pulley mounted on the engine. Remove the
“moving face” of the pulley. Clean the bronze bushing and shaft of gum and belt dust and lu-
bricate with a thin coat of light oil.
3 Disassemble, clean, inspect and re-pack the main chassis wheel bearings.
4 Lubricate all chains.
5 Prepare the Honda engine for storage. See the storage instructions provided in the Honda
engine manual.
BEFORE START UP (After long term storage)
1 Review this manual to refresh your memory regarding the proper operation of this machine.
2 Fill the fuel system with fresh fuel.
3 Change the oil in both the transmission gearbox and the indexer gearbox.
4 Check and adjust the tire pressure to 36 - 40 PSI .
LUBRICANTS
Grease: Any good grade of multi-purpose, waterproof
grease is acceptable.
Engine Oil: Consult the Honda owners’ manual for oil
recommendations.
Transmission Gearbox: SAE 80W or 90W gear oil.
(see illustration)
Indexer Gearbox: Mobile SHC 634 Synthetic Gear
Lubricant
DRAIN PLUG
FULL PLUG
FILLING
AREA
CAUTION
DO NOT leave the machine unattended during the hose draining process. Without fluid pres-
sure present, the hose may flatten slightly causing it to lay improperly on the drum. It may be
necessary to manually adjust the hose position on the hose drum during the draining process.
AS SHOWN WHEN CHECKING THE OIL LEVEL
THE OIL LEVEL HOLE
FILL THE GEARBOX TO THE INSIDE LIP OF