Cadman 4000M, Руководство оператора по эксплуатации и техническому обслуживанию

Страница: 19 / 48

TR-MAN-4500-A
Operator's Manual - 4000M 4500M
Page 17 of 46
Finishing an Application
Step 1
When you are nearing complete coverage of a section, signal the operator to shut
down the pump. Start the hose blow out procedure. Continue to move the applicator
through the field until flow to the applicator has stopped.
The hose is a high volume “Receiver Tank” containing a large amount
of fluid. Be sure to allow enough spreading area to properly apply the
hose content.
o
Ø 6” hose contains approximately 1 ½ US Gallons per foot
o
Ø 8” hose contains approximately 2 ⅔ US Gallons per foot
660 1320 1980 2640 3300 3960 4620 5280 5940 6600
Feet
Ø 6" 969 1939 2908 3877 4847 5816 6785 7755 8724 9693
US Gal
Ø 8" 1723 3447 5170 6893 8616 10340 12063 13786 15509 17233
US Gal
Failure to compensate for the remaining fluid can result in over
application of fluid.
Step 2
Drag the hard hose so that it is back at the original start position. Disconnect the
applicator from the hard hose by uncoupling the ringlock fitting.
End
Position
CORRECT INCORRECT
Figure 16 - Return to End Position
img-00125.wmf