www.cadis.be | [email protected]
Water at the heart of our technology
Press and hold the orange button on the front to connect the wireless
transmitter to the selected channel. The next screen briefly appears:
The wireless sensor is now linked to the selected channel.
The next screen appears:
Repeat these steps from point 3 for the next wireless sensors (power supply for
next wireless sensor).
Once the last wireless sensor has been connected, press and hold the orange
button on the front to return to normal operation. Press until the following
screen appears and the module will return to normal operation.
Removing the wireless sensors from the system:
You can also disconnect wireless sensors from the module. Open the housing by
removing the bottom cover. Briefly press the “Config button” and the following
message appears on the LCD screen:
The AQUAVISION 2DETECT is now in configuration mode for the wireless
sensors. Briefly press the orange button on the front panel and the following
message appears:
Briefly press the orange button on the front panel to scroll to the wireless
sensors that are to be disconnected.
Press and hold the orange button to disconnect the wireless sensor. The sensor
is then removed from the AQUAVISION 2DETECT’s memory.
Next, the following screen appears:
Press and hold the orange button again and the system returns to normal
operation.
Connecting the optional 5 VDC shut-off valve:
In the event of a leak, this alarm module can automatically control a shut-off valve and stop the water supply in the
supply pipe. Only Cadis supplied 5VDC shut-off valves can be fitted.
•
Connect the Red connecting wire of the valve to NO +
•
Connect the Green connecting wire of the valve to NC +
•
Connect the Black connecting wire of the valve to – (minus)
NOTE: A contact on the the shut-off valve indicates the valve’s position. When the valve is closed, there is a closed
contact between the yellow and white connecting wire. If required, this contact may also be forwarded to the BMS
system.
•
Only after all the cables are connected can the housing be closed and the power supply to the module
switched on. Otherwise, there is the risk of damage to the module.
•
The module will operate immediately and normally after switching on the power. Any additional settings for
sending the alarms can be modified retrospectively by the users in the web server of the module using a PC
or a laptop.
