Cadillac XT6 Owner Manual (GMNA-Localizing-U.S./Canada-16405819) -
2023 - CRC - 3/22/22
Seats and Restraints
51
Seat Exit Memory Recall
”
later
in this section. To enable
automatic recalls, turn on Seat
Entry Memory and/or Seat
Exit Memory. See
“
Enabling
Automatic Recalls
”
later in this
section. The memory recalls
may be cancelled at any time
during the recall. See
“
Cancel
Memory Seating Recalls
”
later
in this section.
Identifying Driver Number
The vehicle identifies the
current driver by their remote
key number 1
–
8. The current
remote key number may be
identified by Driver
Information Center (DIC)
welcome message,
“
You are
driver x for memory recalls.
”
This message is displayed the
first few times the vehicle is
turned on when a different
remote key is used. For Seat
Entry Memory to work
properly, save positions to the
1 or 2 memory button
matching the driver number of
this welcome message. To aid
in identifying remote key IDs, it
is recommended to only carry
one remote key when entering
the vehicle. Perform the
following if the welcome
message is not displayed:
1. Move all keys and remote
keys away from the
vehicle.
2. Start the vehicle with
another remote key. A DIC
welcome message should
display indicating the
driver number of the other
remote key. Turn the
vehicle off and remove the
other key or remote key
from the vehicle.
3. Start the vehicle with the
initial key or remote key.
The DIC welcome message
should display the driver
number of the initial
remote key.
Saving Seating Positions
Read these instructions
completely before saving
memory positions.
To save preferred driving
positions to 1 and 2:
1. Turn the vehicle on or to
accessory mode. A DIC
welcome message may
indicate the driver number
of the current remote key.
See
“
Identifying Driver
Number
”
previously in this
section.
2. Adjust all available memory
features to the desired
driving position.
3. Press and release SET; a
beep will sound.
4. Immediately upon releasing
SET, press and hold
memory button 1 or
2 matching the current
Driver
’
s remote key
number until two beeps
sound. If too much time
passes between releasing
SET and pressing 1 or 2,
the two beeps will not
sound indicating memory
position were not saved.
Repeat Steps 3 and 4 to
try again.