Cadillac Escalade Owner Manual (GMNA-Localising-Europe-11374166) -
2018 - crc - 7/14/17
168
LIGHTING
;
:
Turns on the parking lamps
including all lamps, except the
headlamps.
2
:
Turns on the headlamps together
with the parking lamps and
instrument panel lights.
When the headlamps are turned on
while the vehicle is on, the headlamps
will turn off automatically 10 minutes
after the ignition is turned off. When
the headlamps are turned on while
the vehicle is off, the headlamps will
stay on for 10 minutes before
automatically turning off to prevent
the battery from being drained. Turn
the headlamp control to off and then
back to the headlamp on position to
make the headlamps stay on for an
additional 10 minutes.
IntelliBeam
®
System
If equipped, this system turns the
vehicle's main beam headlamps on
and off according to surrounding
traffic conditions.
The system turns the main beam
headlamps on when it is dark enough
and there is no other traffic present.
This
b
lamp comes on in the
instrument cluster when the
IntelliBeam system is enabled.
Turning On and Enabling IntelliBeam
To enable the IntelliBeam system,
with the indicator lever in the neutral
position, turn the exterior lamp
control to AUTO. The blue main beam
on light appears on the instrument
cluster when the main beams are on.
Driving with IntelliBeam
The system only activates the main
beams when driving over 40 km/h
(25 mph).
There is a sensor near the top centre
of the windscreen, which
automatically controls the system.
Keep this area of the windscreen clear
of debris to allow for best system
performance.
The main beam headlamps remain on,
under the automatic control, until one
of the following situations occurs:
.
The system detects an
approaching vehicle's headlamps.
.
The system detects a preceding
vehicle's tail lamps.
.
The outside light is bright enough
that main beam headlamps are
not required.
.
The vehicle's speed drops below
20 km/h (12 mph).
.
The IntelliBeam system can be
disabled by the main/dipped beam
changer or the flash-to-overtake
feature. If this happens, the main/
dipped beam changer must be
activated on then off within
two seconds to reactivate the
IntelliBeam system. The
instrument cluster light will come
on to indicate the IntelliBeam is
reactivated.
See
and
The main beams may not turn off
automatically if the system cannot
detect other vehicle's lamps because
of any of the following:
.
The other vehicle's lamps are
missing, damaged, obstructed from
view, or otherwise undetected.