Cadillac 2010 Escalade Hybrid, Дополнение к руководству пользователя

Страница: 64 / 112

Do not top off the brake fluid. Adding fluid does not
correct a leak. If fluid is added when the linings are
worn, there will be too much fluid when new brake
linings are installed. Add or remove brake fluid, as
necessary, only when work is done on the brake
hydraulic system.
{
WARNING:
If too much brake fluid is added, it can spill on the
engine and burn, if the engine is hot enough. You
or others could be burned, and the vehicle could
be damaged. Add brake fluid only when work is
done on the brake hydraulic system. See
“ Checking Brake Fluid ” in this section.
When the brake fluid falls to a low level, the brake
warning light comes on. See
“ Brake System Warning
Light ” in the owner manual.
Refer to the Maintenance Schedule to determine when
to check the brake fluid. See
“ Scheduled Maintenance ”
in the owner manual.
Checking Brake Fluid
Check brake fluid by looking at the brake fluid reservoir.
See
Engine Compartment Overview on page 6 ‑ 4 .
With the engine not running for at least one minute, the
maximum fluid level (A) is at the top of the reservoir
body. With the engine running, the fluid level should be
in the proper operating range (B) between the MIN and
MAX marks. If it is not, have the brake hydraulic system
checked to see if there is a leak.
After work is done on the brake hydraulic system, make
sure the level, with the engine running, is in the proper
operating range (B) between the MIN and MAX marks.
6-14