7
WARRANTY
For more effective and safer operation and to prolong the
life of the heater, read the Owner’s Guide and follow the
instructions. Failure to properly maintain the heater will
void any warranty and may cause the heater to function
improperly.
LIMITED THREE YEAR WARRANTY:
Cadet will repair
or replace any Com-Pak Bath (CB) heater found to be
defective within three years after the date of purchase.
These warranties do not apply:
1. Damage occurs to the product through improper
installation or incorrect supply voltage;
2. Damage occurs to the product through improper
maintenance, misuse, abuse, accident, or alteration;
3. The use of unauthorized accessories or unauthorized
components constitutes an alteration and voids all
warranties. Refer to Cadet website or call customer
service at 855.223.3887 or 360.693.2505 for list of
authorized accessories and components.
4. Cadet’s warranty is limited to repair or replacement.
5. In the event Cadet elects to replace any part of your
Cadet product, the replacement parts are subject to
the same warranties as the product. The installation
of replacement parts does not modify or extend the
underlying warranties. Replacement or repair of any Cadet
product or part does not create any new warranties.
If you believe your Cadet product is defective, please
contact Cadet during the warranty period, for instructions
on how to have the repair or replacement processed.
Parts and Service
Visit cadetheat.com/parts-service for information on
where to obtain parts and service.
To register your product, visit
cadetheat.com/product-registration
TIMER
MANUAL
RESET HIGH
TEMPERATURE
LIMIT
HEATING ELEMENT
C
B
D
A
MOTOR
L1
L2
3
6
1
4
THERMOSTAT
JUMPER WITH
INSULATED
CONNECTOR
SPARE
TERMINAL
INTERNAL HEATER WIRING DIAGRAMS
TIMER
MANUAL
RESET HIGH
TEMPERATURE
LIMIT
HEATING ELEMENT
C
B
D
A
MOTOR
L1
L2
3
6
1
4
THERMOSTAT
JUMPER WITH
INSULATED
CONNECTOR
SPARE
TERMINAL
TIMER
MANUAL
RESET HIGH
TEMPERATURE
LIMIT
HEATING ELEMENT
C
B
A
MOTOR
240/208
VOLT
POWER
SUPPLY
L1
L2
3
6
1
4
THERMOSTAT
240/208 Volt Power Supply
120 Volt Power Supply
240 Volt Power Supply
1. Make sure all wires are properly
connected and installation is complete
before you turn on the heater.
2. Do not operate without grill.
3. Do not tamper with the high-
temperature safety shutoff.
OPERATING INSTRUCTIONS
Complete installation
After installation, turn your heater to the highest setting and let it run for 30 minutes. Some smoking
may occur as the element initially burns off residue from manufacturing.
If your heater shows signs of overheating, such as glowing red or repeatedly getting unusually hot and
shutting off, immediately turn off the circuit breaker and review the “KNOW YOUR VOLTAGE” section
or call us.
If the high-temperature safety shutoff trips more than once a day, replace the heater.
CB103T MULTI-VOLT
CB132T MULTI-WATT
How to operate your heater
With the thermostat
(knob on right side):
The room temperature is controlled by a thermostat located on the heater. Once installation is com-
plete and power is on, follow the steps below.
1. Turn the thermostat knob all the way to the right.
2. When the room reaches your comfort level, turn the knob to the left, just until it clicks and the
heater turns off. The heater will automatically keep the room temperature around this setting.
3. To reduce the room temperature, turn the knob to the left. To increase the room temperature,
turn the knob to the right.
With the thermostat knob turned all the way to the left, the heater will not come on, but using the timer
will operate the heater.
With the timer (knob on left side):
To operate the heater with the timer, turn timer knob to desired minutes. The timer cancels thermostat
control while it's running. The heater stays on until time is up, even if your room temperature
becomes warmer than the thermostat setting, then control of the heater returns to the thermostat.
