2
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
1. Read all instructions before
installing or using this heater.
2. This heater is hot when in use.
To avoid burns, do not let bare
skin touch hot surfaces. Keep
combustible materials, such as
furniture, pillows, bedding, papers,
clothes, etc. and curtains at least
3 feet (0.9 meters) from the front
of the heater and keep them away
from the sides.
3. Extreme caution is necessary
when any heater is used by or near
children or invalids and whenever
the heater is left operating and
unattended.
4. Do not operate any heater after
it malfunctions. Disconnect
power at service panel and have
heater inspected by a reputable
electrician before reusing.
5. Do not use outdoors.
6. To disconnect heater, turn con-
trol(s) to off, and turn off power to
heater circuit at main disconnect
panel.
7. Do not insert or allow foreign
objects to enter any ventilation
or exhaust opening as this may
cause an electric shock or fire, or
damage the heater.
8. To prevent a possible fire, do not
block air intakes or exhaust in any
manner.
9. A heater has hot and arcing or
sparking parts inside. Do not use
it in areas where gasoline, paint,
or flammable vapors or liquids are
used or stored.
10. Use this heater only as described
in this manual. Any other use not
recommended by the manufacturer
may cause fire, electric shock, or
injury to persons.
11. This heater must be installed in a
fixed, permanent location.
When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons, including
the following:
KNOW YOUR VOLTAGE!
120 vol
t
single-pole breaker
240 vol
t
double-pole breaker
• The multi-volt CB103T is factory set to 240 volts out of the box. It can be easily
changed to 120 volts. Please don’t assume you have 120 volts because your
wires are black and white.
The multi-watt CB132T can only be connected to 240 or 208 volts and its
wattage is adjustable.
If you are uncomfortable working with electricity, running electrical supply wire or
installing a circuit breaker, please consult a licensed electrician. Make sure power
to the heater is turned off at the main disconnect panel whenever doing any work
on a heater. Serious injury or electrocution can result from electric shock.
• CHECK YOUR BREAKER! If you’re replacing an existing heater, check the labels
of the old heater and use the same voltage.
Unanswered questions? Call our technical support team in Vancouver, Washington
toll free at
855.223.3887
or outside the USA
360.693.2505
.
WARNING: Connecting a heater to a voltage higher than what’s listed on its rating
label will destroy the heater and could start a fire. A heater will not heat properly
when connected to a voltage lower than what’s listed on its rating label.
