1. Make sure all wires are properly
connected and installation is com-
plete before you turn on the heater.
2. Do not operate without grill.
3. Do not tamper with the high-tem-
perature safety shutoff.
OPERATING INSTRUCTIONS
Digital Display and Control Buttons
NIGHT/AWAY MODE
Program a lower temperature for energy
savings at night, or if you’re not in the room.
• In HEAT mode, press . Display shows
MAX/MIN TEMPERATURE LOCK
Program maximum and/or minimum tempera-
ture settings as a child safety or tamper-proof
option.
MAXIMUM 86
˚
F (30
˚
C):
• In FAN mode, press and hold and at
the same time, until display shows
temperature.
• Release buttons. While temperature alter-
nates with
HL
, use or to set maximum
temperature.
MINIMUM 40
˚
F (4.4
˚
C):
• Press . While temperature alternates
with
LL
, use or to set minimum
temperature.
Wait 10 to 15 seconds and display returns to
0
. Your settings are saved.
To change the lock temperatures, follow the
same instructions.
START HEATING/SET TEMPERATURE
• In HEAT mode, press or to adjust
temperature.
FAN MODE
Stops heating, or circulates air without heat.
• In HEAT mode, press . Fan runs at a
low level until heater cools down. This
lasts for 5 to 10 minutes.
When fan stops completely,
NO
shows
in display.
• In FAN mode, press or to adjust fan
speed.
CHANGE DISPLAY TO CELSIUS
• In FAN mode, press and hold and at
the same time, until display shows
temperature.
• Release buttons. Press twice. Display
alternates between
o
F
and
U
.
• Press to convert to Celsius. Press to
convert back to Fahrenheit.
• Wait 10 to15 seconds and display returns to
0
. Your settings are saved.
HEAT MODE
Digital display
shows room temperature, and
the level of heat being output.
Full
Power
Medium
Power
Low
Power
Fan Only /
High Speed
Night / Away
Mode
Night/Away
Mode
Heat
Output
Temperature
Fan
Operation
Up
Down
Night/Away
Heat/Fan
Mode
Stop Heating /
No Fan
u
SWITCHING MODES
Use button to change between modes.
In HEAT mode, display shows temperature.
In FAN mode, display shows
0
,
1
,
2
or
3.
Your Energy Plus heater has a variable speed blower that auto adjusts heat output based on the tem-
perature setting. The heater varies wattage output for maximum efficiency. Temperature Range: 40
˚
F
to 86
˚
F (4.4
˚
C to 30
˚
C). The room temperature is controlled by the built-in digital thermostat. A wall
thermostat cannot be used with this heater.
NO
NO
moon icon.
• Press or to adjust
temperature. The default
low temperature is 55
˚
F
(12.8
˚
C).
• Fan runs at a low level until
heater cools down. This
lasts for 5 to 10 minutes.
To exit NIGHT/AWAY mode when you wake or
return, press .
7
Complete installation
After installation, turn your heater to the highest setting and let it run for 30 minutes. Some smoking may
occur as the element initially burns off residue from manufacturing.
If your heater shows signs of overheating, such as glowing red or repeatedly getting unusually hot and
shutting off, immediately turn off the circuit breaker and review the “KNOW YOUR VOLTAGE” section or
call us.
If the high-temperature safety shutoff trips more than once a day, replace the heater.
