cadenbach MINERVA, Быстрый старт

Страница: 8 / 9

Save operating
Protecting your speaker
MINERVA
10 inch FIR point source loudspeaker
MINERVA speakers may be used in combination with Cadenbach Acoustics
PAX Amplifiers and Cadenbach Acoustics HEIMDALL controller.
In general, audio signals must not be over driven. This may be caused by
mixing consoles, equalizers, effect equipment, etc. and should be indi-
cated on this equipment. When a power amplifier is over- loaded at the
output (clipping), then the amplifier activates a clipping warning signal.
In any case, the signal must be reduced as soon as it sounds unnaturally
distorted.
Damage caused by overloading the speakers or using the speakers with-
out Cadenbach Acoustics PAX and HEIMDALL we do not assume warranty
and excludes liability for possible consequential damage.
Permanent high-level signals with high frequency and continuous noise
from feedback or permanently distorted high-level signals or noises,
which occur when the amplifier is on while equipment is being connected,
disconnected or switched on could damage the loudspeakers.
Do not install loudspeakers at places where they are permanently ex-
posed to direct sunlight, high moisture, direct rain or strong vibrations
and dust.
www.cadenbach.eu