Cadel ROXY, Руководство пользователя

Страница: 21 / 40

21
ATRIUM AT 5kW-ROXY-MADISON-SOLO-TABLA
When the flue gas temperature has reached and exceeded the intended value, the stove goes into the normal operating mode. The
display shows the word Work " uorK " and the ON/OFF LED is lit.
The power can be set by keeping button P2 pressed and the room temperature can be set by pressing button P1.
At set intervals, an automatic burn pot cleaning is performed in order to prevent dash from accumulating. On the display you will
see
Cleaning fire-pot
“ cLEAninG FirE-Pot ”.
If this function lasts for a few seconds, it is NOT an alarm.
Fig. 19 - Display
8.5 FAILED IGNITION
If the pellets do not burn, the failed ignition will be indicated by the alarm AL 5 FAILED IGNITION " AL 5 ALAr no LiGHtin ".
If the room temperature is lower than 10°C, the plug is not able to bear the ignition stage. To support it please insert some pellets
in the burning pot and a piece of burning firelighter igniter material on the pellets (for example firelighters cubes).
Too much pellets in the burning pot, or humid pellet, or sooty burning pot make ignition difficult and create dense white smoke
which is harmful to health and can cause explosions on the combustion chamber. It is therefore necessary not to stand in front of
the stove during ignition stage if dense white smoke is present.
If after some months the flame appears weak and/or orange colored or the glass tends to blackens and the
burning pot to become encrusted, clean the stove, clean the fume conduit and the chimney flue.
8.6 POWER FAILURE
After a Black-out " bLAc-out " lower than 5 seconds, the stove turns back to the power which was settled.
After a
Black-out
" bLAc-out "of more than 5 seconds, the stove enters the
COOLING WAIT
" uAit cooLinG " phase. Completed this
phase, it starts automatically up with the different phases (see STOVE SWITCH-ON a pag. 20 ).
8.7 TEMPERATURE SETTING
Change the room temperature by simply pressing button P1 .
The display shows the set room temperature (
temperature SETTING
).
Therefore, the value can be changed by pressing buttons P1 (decreases) and P2 (increases ).
After about 5 seconds the value is saved and the display returns to normal display, or exit by pressing
P3
.
8.8 POWER SETTING
Change the set power by simply pressing button P2. The display shows the set power (power SETTING). Therefore, the value can be
changed by pressing buttons P1 (decreases) and P2 (increases ).
After about 5 seconds the value is saved and the display returns to normal display, or exit by pressing P3.
NOTE: when the room temperature has reached the set value, the heating power of the stove is automatically brought to the mi-
nimum value. In these conditions, the display shows the message Modulate “ ModuLAt ”.
If the room temperature drops below the set temperature, the stove returns to “ Work " uorK " mode at the previously set power.
8.9 SWITCHING OFF
Switch the stove off by simply pressing and holding down button P3. Pul-Finale "cLEAninG SPEEd " appears on the display.
After a certain time, the stove switches off, and
Off
" oFF " is displayed.
8.10 CONNECTION TO THE EXTERNAL THERMOSTAT
The stove works through a thermostat probe placed in its inner. If you desire, the stove can be connected to an external room
thermostat. This operation must be executed by an authorized technician.