CADDX RANGER 7600, Руководство пользователя

Страница: 5 / 10

5
TURNING ON THE CHIME FEATURE
If checked, your security system will operate in the "CHIME" mode, allowing the monitoring
of pre-designated zones while the security system is not armed. While in the "CHIME" mode,
the opening of any of these zones will produce a 1 second beep from the keypad control. To
activate this feature, press [ 1 ] for "CHIME" mode. Five seconds after pressing the "CHIME"
digit, a one second tone will occur indicating that this feature has been activated. Repeat this
procedure to turn the "CHIME" feature off.
KEYPAD ACTIVATED PANIC/HOLD-UP ALARM
If checked, this feature has been selected by your installing company. If so, when the star [
r
]
and pound [#] keys are pressed at the same time for one second, a local audible alarm will
sound. If your system is connected to a monitoring center, an emergency report could be
transmitted to that center. These keys should only be pressed in an emergency situation
requiring immediate response by law enforcement personnel.
PLEASE NOTE: Some Panic/Hold-Up alarms are programmed to be silent at the protected
site while reporting an alarm to the monitoring center. Check with your installing company to
determine how your security system will respond to the Panic/Hold-Up activation.
KEYPAD ACTIVATED FIRE ALARM
If checked, this feature has been selected by your installing company. If so, you can activate
the Fire alarm by pressing the one [1] and three [3] keys at the same time for one second. If
your system is connected to a monitoring center, an emergency report could be sent to that
center. These keys should only be pressed in an emergency situation requiring response by
fire department personnel.
KEYPAD ACTIVATED AUXILIARY ALARM
If checked, this feature has been selected by your installing company. If so, you can activate
the auxiliary alarm by pressing the four [4] and six [6] keys at the same time for one second.
If your system is connected to a monitoring center, an emergency report could be sent to that
center. These keys should only be pressed in an emergency situation requiring response by
emergency personnel.
FIRE ZONE
If checked, your system has zones designated as "FIRE" zones. When this option is selected,
and approved heat or smoke detectors are attached to these selected zones, a Fire alarm
sound can be initiated from the security system. You should familiarize yourself and your
family or staff with this sound (see page 1, Fire Alarm sound) and follow an evacuation plan
if this "FIRE" alarm sound is heard. (see page 8 for assistance in formulating an evacuation
plan). To silence the audible "FIRE" alarm sound, enter a valid code. To reset the zone LEDs
designated as "FIRE" zones and /or smoke detectors, press the [#] key (reset) on the keypad.
After 10 seconds, the zone LEDs designated as "FIRE" zones should extinguish, and the light
on the affected smoke detector should go out. If you are unable to reset the LEDs for
designated "FIRE" zones or smoke detectors after all smoke has cleared, you should
immediately call the service phone number listed on page 1 of this booklet.