CADDX RANGER 7600, Руководство пользователя

Страница: 3 / 10

3
HOW TO ARM YOUR SECURITY SYSTEM
To Arm the security system, close all of the protected doors and windows. The green
"READY" light on the keypad control will be illuminated when all of the protected zones and
sensors are secure. If any of the zones are bypassed, a sensor in that zone can be violated
without affecting the "READY" light. The security system will not arm if the "READY" light is
not illuminated unless "FORCE ARMING" has been enabled (see "FORCE ARMING" page
4). With the "READY" light on, you may arm the security system with your Master Code or one
of the auxiliary codes. Each time a key is pressed on the keypad control, a short tone (beep)
will sound. If the keypad beeps three times after a code entry, it is an indication that code has
not been accepted. Press the [#] key (reset) and re-enter a valid code. If the keypad control
beeps continuously after code entry, it is an indication that the "POWER" light is off, meaning
there is no AC power to your system. The keypad sounder can be silenced by re-entering your
four digit code. If the "POWER" light is off, you should restore power to the system if possible.
If you are unable to correct the above conditions, you should contact the installing company
listed on page 1 of this booklet for service. When the security system has accepted a valid
code, the red "ARMED" light will illuminate indicating that the system has been turned on. If
you choose to leave the protected area, you must exit through a designated exit door within
the exit delay time noted on page 1. If you choose to stay within the protected area, insure that
all interior zones which may be tripped by your movement are bypassed.
HOW TO DISARM YOUR SECURITY SYSTEM
When you enter the protected area through one of the designated entry/exit doors, the keypad
control will sound a continuous tone (beep) for the duration of the entry delay time, or until you
enter a valid code. After a valid code has been entered, the red "ARMED" light will turn off,
and the tone will stop. The security system is now DISARMED. If a valid code is not entered
before the end of the entry delay time, an alarm will occur. (NOTE: IF THE RED "ARMED"
LIGHT IS FLASHING DURING THE ENTRY DELAY, THE ALARM SYSTEM HAS BEEN
ACTIVATED IN YOUR ABSENCE. LEAVE THE BUILDING IMMEDIATELY AND CALL YOUR
ALARM COMPANY AND/OR THE POLICE FROM A SAFE LOCATION.)
HOW TO BYPASS ZONES
When zones are open or unsecured, their corresponding LEDs will flash. To bypass any of the
zones, press [
r
], zone number(s) to be bypassed, and [
r
]. When bypassed, corresponding
zone LEDs will be on steady. Zones cannot be bypassed or unbypassed while the control is
in the armed state. Upon disarming, all bypassed zones will be unbypassed. As bypassed
zones are not protected, the bypass procedure should only be given to authorized persons.
QUICK-ARM FEATURE
If checked, your security system has a "QUICK ARM" code programmed. This feature will
allow you to arm the security system by pressing one, pre-designated key on the keypad
control. This "QUICK ARM" code is for
ARMING ONLY, and will not disarm the security
system. This makes it ideal for a maid code, babysitter code, etc. This code can only be
programmed and/or changed by your installing company.