Cadac S-Type, Инструкция по установке и эксплуатации, Страница: 24 / 74

4-6 Mono input module 8411
S-Type Revision S2005-6
714154 +) # (4 # &XW 2 %RRVW #)# )UHTXHQF\ # FRQWURO #4 N 8 +] 048 N+]
This dual concentric potentiometer allows the centre frequency to be adjusted
between 1k5Hz and 15kHz (lower control) and the gain to be adjusted by ±18dB
(upper control). The gain control is centre detented.
714155 +) # 4 0 FRQWURO
The Q-control varies the bandwidth of the selected frequency selected as per 4.1.21.
As indicated on the front panel when turned towards the low ‘Q’ symbol (Q approxi-
mately 1.0) will cause a wide bandwidth of frequencies to be affected around the
selected centre frequency. When set towards the high ‘Q’ symbol (‘Q’ approximately
3.0) a narrow band of frequencies will be affected around the centre frequency.
714156 +0) # (4 # &XW 2 %RRVW #)# )UHTXHQF\ # FRQWURO #733 +] #0#7 N+]
This dual concentric potentiometer allows the centre frequency to be adjusted
between 400Hz and 4kHz (lower control) and the gain to be adjusted by ±18dB
(upper control). The gain control is centre detented.
714157 +0) # 4 0 FRQWURO
The Q-control varies the bandwidth of the selected frequency selected as per 4.1.23.
The function of the Q-control is described in 4.1.22.
714158 /0) # (4 # &XW 2 %RRVW #)# )UHTXHQF\ # FRQWURO #93 +] #0#933 +]
This dual concentric potentiometer allows the centre frequency to be adjusted
between 60Hz and 600Hz (lower control) and the gain to be adjusted by ±18dB
(upper control). The gain control is centre detented.
714159 /0) # 4 0 FRQWURO
The Q-control varies the bandwidth of the cut/boost frequency selected as per
4.1.25. The function of the Q-control is described in 4.1 22.
71415: /) # (4 # &XW 2 %RRVW #)# )UHTXHQF\ # FRQWURO #53 +] #0#533 +]
This dual concentric potentiometer allows the centre frequency to be adjusted
between 20Hz and 200Hz (lower control) and the gain to be adjusted by ±18dB
(upper control). The gain control is centre detented.
71415; /) # 4 0 FRQWURO
The Q-control varies the bandwidth of the cut/boost frequency selected as per
4.1.27. The function of the Q-control is described in 4.1.22.