Cadac S-Type, Инструкция по установке и эксплуатации

Страница: 21 / 74

Mono input module 8411 4-3
Revision S2005-6 S-Type
71419 'LUHFW # RXWSXW # VHOHFW
Normally the direct output is fed post fader; pressing PRE will source the signal pre-
fader but post INS/EQ. Pressing MIC will override the PRE button (the PRE LED will
extinguish) and source the Direct Output post MIC amplifier. In this condition the HP-
filter is still available.
7141: 'LUHFW # RXWSXW # OHYHO # FRQWURO
Use this rotary control to adjust the direct output level. Level control is from infinitity
to 0dB.
7141; 6XE 0 JURXS # URXWLQJ
The sub-group routing buttons allows a post fader signal to be routed to the Sub-
Groups, with optional pan information, see 4.1.11. To route a signal from an input
channel to a Sub-Group, press the relevant numerical button in the Sub-Group sec-
tion of the input module.
5RXWLQJ # WR # PDWUL[ # RXWSXW
Before you can route a signal to the matrix outputs, the signal has to be routed to one
of the sub-groups (see 4.1.8). The signal can then be routed to the matrix output by
using the opposite controls on the 8413 & 8415 module.
7141< 67 #0# 6WHUHR
Pressing this button routes a post pan and fader signal to the stereo master. The pan
potentiometer will affect this signal regardless of whether the pan button is pressed,
see 4.1.11.
714143 3DQ
Press this button to enable panning of the sub-groups via the pan potentiometer.
714144 3DQ # FRQWURO
Use this rotary control to pan the signal within the stereo field.