Cabrinha CROSSBOW 2006, Руководство пользователя

Страница: 52 / 57

06
48
REPAIRING LEADING EDGE BLADDERS
• First, lay the kite out with the struts facing up.
• Each end of the Leading Edge (LE) bladder is folded over and secured
with a Velcro closure. You will also find a zipper access pocket at the
center of the LE. Undo each Velcro closure and unzip the center access
pocket. This will open up the sleeve of the strut and will allow you access
to the bladder. (Fig. 1,2)
• Separate the Airlock Valve Assembly from the leading edge. Carefully lift
the retainer ring from the bladder. Keep track of the assembly for later
use. (Fig. 3,4,5)
• Next, on the standard valve, separate the valve plug from the Velcro clo-
sure so that the valve is free from the strut’s sleeve. This will essentially
disconnect the bladder from the sleeve. Keep track of the valve plug for
later use.
• For the next step, you will need two flying lines. Starting with one end
of the leading edge, tie one line around the wing tip end of the bladder.
Cinch the line down well. Using the second line, follow the same proce-
dure with the other end of the leading edge bladder. (Fig. 6)
• Next, gently push the valves down into the strut sleeve.
• Now, access the leading edge bladder through the zippered access pocket
near the leading edge valve. (Fig. 7)
• Gently pull one side of the bladder out of the sleeve at a time, leaving the
flying line through both sides of the sleeve. Having the flying line through
the sleeve will allow you to easily replace the bladder once it is repaired.
• Once out of the sleeve, inflate the bladder and plug both valves so that it
maintains air. Do not over inflate the bladder.
• Submerge the bladder in water to locate the hole. A bathtub or large sink
full of water is best. You will need to submerge one section of the bladder
at a time in order to locate the hole. Look for air bubbles to locate the
hole.
• Once you have located the leak, dry the area and mark the hole with a
circle. A permanent marker works best for this. (Fig. 8)
• Dry and clean the rest of the bladder with a soft towel.
• Again, deflate the bladder.
• Decide whether to use the glue or a patch supplied in your bladder repair
kit.
• If the hole is on a seam, you will need to glue the area.
• If the hole is on a flat area of the bladder, remove the backing on one of
the patches and press it onto the bladder, covering the hole.
• Set the bladder aside for approximately 20 minutes to dry.
1
2
3
4
5
REPAIRS
LEADING EDGE BLADDERS