Cabrinha CROSSBOW 2006, Руководство пользователя

Страница: 30 / 57

06
26
SETUP #1
CHECK YOUR LINE LENGTHS
1.1 CHECK YOUR LINE LENGTHS
The 2006 control bars come set up with the flying lines attached; however, it is wise to
check your line lengths before going on the water. To do so, follow the directions below:
CAUTION:
The Frontline and Override Control systems can be adjusted in the same
manner as outlined below.
• Loop a piece of line (any rope or cord) around a tree or fence post.
• Tie the line in a knot around the tree, leaving a piece long enough to attach all lines.
• Roll out the flying lines from the post and set the control bar on the ground, facing
up, with the yellow control lines on the left and the black control lines on the right
(looking from your bar to the post). Make sure there are no obstructions in between
your bar and the post. The Frontline will remain in the middle of the 4 control lines.
• Make sure your flying lines are not twisted or crossed.
• At the ends of the flying lines nearest the post you will notice that there are eyelets
on the rear steering lines and front de-power lines. The overhand knots on the front
(de-power) lines are there to eliminate incorrect connection to the kite.
• Take the rope attached to the post and feed it through the eyelets on all five lines,
with the yellow on the left and the black on the right.
• Tie a bowline knot, with all five lines inside the loop.
• Walk back to the control bar.
• Make sure that the centerline adjustment strap is fully extended, so that the kite is
set up at full power.
• Standing directly in line with the post, pull back hard and steady on the control bar
by pulling straight back toward yourself.
• Your control bar should be in line with your shoulders and should be straight and not
at an angle.
• All of the lines should have even tension under pressure. (I.e. no slack in the de-
power lines, steering lines, or Frontline).
• If your control bar is even, your Control
System is ready to attach to your
inflated kite.
If your control bar is even, proceed to
SETUP 2 - INFLATING YOUR KITE
If your control bar is NOT even, follow the
instructions in SETUP 1.2 - LINE LENGTH
CORRECTIONS