INSTALLING THE TRFOT-3
Page 3-1
CHAPTER 3
INSTALLING THE TRFOT-3
This chapter outlines how to install the TRFOT-3 to your network.
Ensure that your network meets all the requirements listed in
Chapter 2,
Installation Requirements/Specifications
, before
installing and operating the TRFOT-3.
3.1
UNPACKING THE TRFOT-3
Unpack the TRFOT-3 as follows:
1.
Carefully remove the TRFOT-3 from the shipping box.
2.
Remove the TRFOT-3 from its protective plastic bag.
3.
Visually inspect the TRFOT-3. If there are any signs of damage,
contact Cabletron Systems Technical Support immediately.
3.2
SETTING THE CONFIGURATION SWITCHES
Figure 3-1 shows the location of the TRFOT-3’s four configuration
switches. Cabletron sets the switches for Station applications. If you
need to change the switches for other applications, follow steps 1-3.
Figure 3-1. TRFOT-3 Configuration Switches
1.
Disconnect the TRFOT-3 from the network and remove the power.
2.
Set the switches for the desired application (refer to Table 3-1).
3.
Reconnect the TRFOT-3 to the network, then re-apply the power.
A B C D
ON
OFF
