Chapter 2: Hardware Installation
68
SSR 8000/8600 Getting Started Guide
To install a line card:
1.
If a cover plate is installed over the line card slot, use the #2 Phillips-head screwdriver
to remove it.
2.
Slide the line card all the way into the slot, firmly but gently pressing the line card
fully in place to ensure that the pins on the back of the line card are completely seated
in the backplane.
Note:
Make sure the circuit card (and not the metal plate) is between the card
guides, as shown in
Figure 34 on page 63
. Check both the upper and lower
tracks.
3.
Use the #2 Phillips-head screwdriver to tighten the captive screws on each side of the
line card to secure the line card to the chassis.
4.
Repeat the above steps for the remaining cards.
5.
When you are ready to attach the segment cables, use the procedures in
“Attaching
the Segment Cables” on page 72
.
Installing the ATM PHY Cards
Each ATM line card has two slots available for PHY cards. One ATM PHY card can be
installed into each available slot. You will need a #2 Phillips-head screwdriver to perform
this procedure.
Figure 38
shows an example of how to install a PHY card. The procedure following the
figure describes how to do this.
Содержание SmartSwitch 8000
Страница 1: ...SmartSwitch Router 8000 8600 Getting Started Guide 9032552 06...
Страница 120: ...Chapter 4 Installing and Starting Cabletron CoreWatch 106 SSR 8000 8600 Getting Started Guide...
Страница 124: ...Appendix A Troubleshooting 110 SSR 8000 8600 Getting Started Guide...
Страница 128: ...Appendix B Technical Support 114 SSR 8000 8600 Getting Started Guide...
