– 5 –
Installing an Ethernet Port Interface
Module (EPIM)
The ELS100-16TX provides two slots for a Cabletron EPIM-100FX
(Ethernet Port Interface Module). The ELS100-16TX is shipped
without EPIMs. To install an EPIM, follow the procedure below:
1. Remove the coverplate or the existing EPIM (whichever
applies).
2. Slide the new EPIM into place, making sure that the
connectors on the rear of the EPIM align correctly and firmly
with the connector inside the ELS100-16TX. Refer to figure.
3. Install the mounting screw.
Caution:
When removing an EPIM, pull the module straight out to
prevent damage to the connector.
Only qualified personnel should perform installation
procedures.
Note:
The EPIM is hot swappable. Also, the RJ45 port
corresponding to the EPIM port is disabled once an EPIM is
installed.
10X 12X 14X 16X
9X 11X 13X 15X
EPIM100
EPIM100
EPIM-100FX
LNK
EPIM-100FX
LNK
