Cabletron Systems pmn, Руководство пользователя

Страница: 92 / 150

Chapter 5: Local Management
5-44 2M46-04R/2M46-04RDC User’s Guide
5.14 HIGH SPEED INTERFACE CONFIGURATION
SCREEN
The High Speed Interface Configuration screen, Figure 5-19 , applies only
to Fast Ethernet Interface Module ports 1 and 2. This screen supports the
FE-100TX, FE-100FX, and FE-100F3 Fast Ethernet Interface Modules
that operate at 10 or 100 Mbps.
If you are configuring an HSIM which is installed in the 2M46-04R, use
the arrow keys to highlight the HSIMS menu item and press ENTER.
Then refer to the applicable HSIM User’s Guide for further information.
The High Speed Interface Configuration screen displays the types of
interfaces installed in ports 1 and 2, their current operating mode, and
indicates if the ports are linked. This screen also allows the user to enable
or disable Auto-Negotiation and set the Advertised Ability.
To access the High Speed Interface Configuration screen from the High
Speed Interface Configuration Menu screen, use the arrow keys to
highlight the FAST ETHERNET INTERFACES menu item and press
ENTER. The High Speed Interface Configuration
screen displays.
Figure 5-19 High Speed Interface Configuration Screen
Firmware Revision: XX.XX.XX
High Speed Interface Configuration
2314-24
Device Type: 2M46-04R
BOOTPROM Revision: XX.XX.XX
Port 1
FE-100TX
Link
100Base-TXFD
[Auto-Negotiation]
[100Base-TXFD] [Disabled]
RETURN
2M46-04R LOCAL MANAGEMENT
Event Message Line
SAVE
Port Type
Link Status
Current Oper. Mode
Desired Oper. Mode
Advertised Ability
Port 2
Unknown
N/A
[N/A]
[N/A]
[N/A]
EXIT